Dotco 14-2631 Router Guide For Router Bits with 3/8" Shank Bits

Built for controlled routing with larger shank cutters, the Dotco 14-2631 Router Guide is a guide accessory for router bits with 3/8" shanks. It is made for use on Dotco 12-10, 12-20, 12-25, and 12-40 series routers, helping operators maintain steady bit positioning during trimming, shaping, and edge-routing work.

This guide has dimensions of A: 2-1/2", B: 5/8", C: 5/8", and D: 1/8", giving buyers the key fitment values needed when matching the guide to the router setup, bit length, and desired bit protrusion.

Type: Router Guide | Model: 14-2631 | Compatible Bit Shank: 3/8" | Dimensions A: 2-1/2" | Dimensions B: 5/8" | Dimensions C: 5/8" | Dimensions D: 1/8"

Important: Insert the bit into the collet as far as possible, then pull out 1/16” and tighten the collet.

In an emergency: If it is necessary to pull out the bit more than 1/4”, be sure to insert a short length of blank shank (not to exceed 5/8” long) in the bottom of the collet before inserting the bit.

Applications:

• Composite trimming and edge routing using compatible Dotco routers.
• Aerospace and fabrication routing where guide dimensions must match the setup.
• Plastic, laminate, and panel routing with 3/8" shank router bits.
• Maintenance replacement for existing Dotco router guide configurations.

FAQs:

• Q: What router bit shank size does this guide fit?
  A: The Dotco 14-2631 is for router bits with 3/8" shanks.
• Q: Which Dotco router series can use this guide?
  A: It is listed for use on Dotco 12-10, 12-20, 12-25, and 12-40 series routers.
• Q: Is this a router or an accessory?
  A: This is a router guide accessory only. The router and router bit are not included.

Looking for more information about Dotco Accessory? Click here to view the Catalog.

Need help selecting the correct Dotco Accessories for your application? Please call (800) 608-5210 or email info@intlairtool.com