Dotco 14-2538 Router Guide For Router Bits with 3/8" Shank Bits

Built for controlled routing work with compatible Dotco pneumatic routers, the Dotco 14-2538 Router Guide supports router bits with 3/8" shanks and provides a guided reference point for cleaner, more consistent cuts. This accessory is used when the router bit must follow a controlled path during trimming, profiling, or template-guided routing operations.

The 14-2538 guide features Dimension A: 1-1/2", Dimension B: 1/2", Dimension C: 1/2", and Dimension D: 1/8", giving buyers a clear dimensional match point when replacing an existing guide or selecting the correct guide for a specific routing setup.

Type: Router Guide | Model: 14-2538 | Compatible Bit Shank: 3/8" | Dimension A: 1-1/2" | Dimension B: 1/2" | Dimension C: 1/2" | Dimension D: 1/8"

Important: Insert the bit into the collet as far as possible, then pull out 1/16” and tighten the collet.

In an emergency: If it is necessary to pull out the bit more than 1/4”, be sure to insert a short length of blank shank (not to exceed 5/8” long) in the bottom of the collet before inserting the bit.

Applications:

• Composite trimming and routing operations.
• Aerospace and fabrication shop router setups.
• Template-guided routing with compatible Dotco routers.
• Replacement guide selection for existing 3/8" shank router bit applications.

FAQs:

• Q: Is the Dotco 14-2538 a router or an accessory?
  A: It is a router guide accessory, not a complete router.
• Q: What router bit shank size does this guide support?
  A: This guide is for router bits with 3/8" shanks.
• Q: What dimensions should I verify before ordering?
  A: Confirm Dimension A: 1-1/2", Dimension B: 1/2", Dimension C: 1/2", and Dimension D: 1/8" against your required setup.

Looking for more information about Dotco Accessory? Click here to view the Catalog.

Need help selecting the correct Dotco Accessories for your application? Please call (800) 608-5210 or email info@intlairtool.com