Dotco 14-2542 Router Guide For Router Bits with 3/8" Shank Bits

Built for guided routing setups using compatible Dotco pneumatic routers, the Dotco 14-2542 Router Guide is made for 3/8" shank router bits. This accessory helps support controlled bit positioning during trimming, profiling, and template-guided routing work where guide dimensions must match the router setup.

The 14-2542 router guide features Dimensions A: 1-1/2", B: 9/16", C: 5/8", and D: 1/8", providing buyers with key dimensional reference points for replacing an existing guide or configuring a compatible Dotco router assembly.

Type: Router Guide | Model: 14-2542 | Compatible Bit Shank: 3/8" | Dimension A: 1-1/2" | Dimension B: 9/16" | Dimension C: 5/8" | Dimension D: 1/8"

Important: Insert the bit into the collet as far as possible, then pull out 1/16” and tighten the collet.

In an emergency: If it is necessary to pull out the bit more than 1/4”, be sure to insert a short length of blank shank (not to exceed 5/8” long) in the bottom of the collet before inserting the bit.

Applications:

• Composite material trimming with compatible Dotco routers.
• Aerospace routing and laminate edge finishing.
• Template-guided routing in industrial fabrication shops.
• Replacement guide use for router setups requiring the listed A, B, C, and D dimensions.

FAQs:

• Q: Is the Dotco 14-2542 a router guide or a router bit?
  A: It is a router guide accessory. Router bits and the router tool are sold separately.
• Q: What router bit shank size does this guide fit?
  A: This guide is for router bits with 3/8" shanks.
• Q: What dimensions should be checked before ordering?
  A: Verify Dimension A: 1-1/2", Dimension B: 9/16", Dimension C: 5/8", and Dimension D: 1/8" against your existing guide or required setup.

Looking for more information about Dotco Accessory? Click here to view the Catalog.

Need help selecting the correct Dotco Accessories for your application? Please call (800) 608-5210 or email info@intlairtool.com